A broken roof demands instant repair. However, in some circumstances, instant repair is not
possible. For example, during heavy rains, the repair work cannot be brought about. You will
have to wait till the rain stops. At times like such, a roof tarp hire in Melbourne is extremely
useful to cover your roof. It can instantly repair and temporarily prevent your ceiling and the
walls from leakage. For effective prevention, it is necessary to tarp your roof properly. It should
be done rightly to save further damage. A high quality tarp cannot really help you if its
installation is improper.

An average roof tarphire covers your roof and protects your interiors for a maximum of 90
days, obviously subject to weather conditions. If you have a prior knowledge of installing a tarp
on your roof, then you can instantly help repairing it during disasters. As it is said, prevention is
always better than cure.

Given below is a detailed description of how you should tarp your roof.

Step One: Identification of the defect:
It is necessary to identify the broken part. Check out the interiors of your house for any
damages. Then look out for broken tiles from the top. The section with the broken tiles should
be covered fully. Make sure you leave some buffer amount of tarp around it.

Step Two: Unfold the tarp:
Now that you know the region that needs the roof tarp hire and the covering, unfold the tarp
according to that size. The calculation should start from the eave of your roof. Leave up to 4
feet of the tarp from the end up to the top of the roof. Leave another 4 feet of the tarp from
another end. Once the measurements are done right, cut this portion well using a utility knife.
Be aware of not making cuts anywhere else.

Step Three: Measure the width of the tarp:
To secure the tarp properly, cut 38 × 39 mm of the tarp using an electric saw or hand. It should
be corresponding the length of the tarp that is needed.

Step Four: Wrap up the boards:
Place a board on each end and fix it up with a nail to ensure that it stays put. Ensure that the
board is flat with respect to the roof. This will not allow the leaves and the rainwater to collect.
The tarp shall flush with the rain water not allowing anything to collect in it.

Step Five: Use another board:Take another board. This board will be used on the top of the tarp. Then use 3 ¼ nails to nail
and secure them together.

Step Six: Place the tarp:
Once the boards have been placed properly, spread out the tarp over and around the peak of
the roof.

Step Seven: One board over the other:
You have to then take another board and place it over the previously nailed board. Then ensure
that you nail both of them together, and your roof is now safe.